Barrel Plug

Shot-Gun 10 gauge Caliber

.79 - 1.02" X 1"

Fits 12 Gauge Chamber and 10 Gauge no choke.

Keep in mind all plugs must be enough larger than the hole diameter so it both fits tight enough so it won't "pop out" due to expanding (due to Parkerizing fluid) air and also to be able to remove easily (Material sufficient to "grab and pull out")

This is high-durability, wide temperature Silicone that tapers to fit from 12 Gauge Shotgun chamber of break-open shotguns to both ends of the 10 Gauge Shotgun

For 10 and 12 Gauge Shotguns. depending on the action and the choke on the barrel, if any. But measure for yourself. The dimensions are 1.02" at the wide end to .79" on the narrow end.

At 1.00 inch long, it is short enough to save you some money: since this material is very expensive.

Each of these plugs will survive many uses in this solution - or for preventing cold, warm or hot bluing from penetrating - one advantage of Silicone.

A picture will be added later.

<< Barrel Plugs